Spent the last few days playing with the new Futaba 10C transmitter.

I had to re-calibrate the joysticks with the RoboteQ AX3500, and took the opportunity to review my speed controller setup, and tweak some of the parameters. After I was done looked like something like this –

Control Input: RC
Motor Control Mode: A and B Mixed
Input Adjustment: Logarithmic Strong
Amps Limit: 60
Acceleration: 682 (milliseconds)

I changed the Input Adjustment to Logarithmic (from Exponential) and decreased the Acceleration Delay to 682 ms. This controls how fast Artoo reaches his maximum speed and time to stop. I found that anything lower made him too jerky as he tries to stop on a dime. Both these parameters will make Artoo a little bit more responsive.

On the Futaba I increased the end points on each of the servo channels to 140%, but I suspect I could have left them at 100% due to the joystick calibration on the RoboteQ.

I also had had to reverse the direction on some of the channels.

I’ve managed to get the signal Fail Safe to work on the Futaba. Many of the older Futaba can’t do this, or at least not on all channels. For example, I know the 7 ch 2.4Ghz receiver can only do it on channel 3/Throttle. Which makes sense for airplanes, but not very good for robotic applications.

The default setting on the 10C is “Nor” which will set the receiver to continue to send the last good signal received out to the servo, or in my case the speed controller. This would cause the droid not to stop if I ever lost power on the transmitter or it’s link to the receiver in the droid.

Hoping that I’ll never need to use it, but at least it’s setup now.

As a side note, I’d almost went with an RC setup from Spektrum which offer a separate receiver (BR6000) specifically design for robotics, but it’s only 6 channels and I’m not crazy about the Spektrum transmitter setup, and really liked the extra knobs and sliders on the Futaba 10C.

I’ve also discovered that the extra FM antenna on the 10C is easily removed, and has zero effect in the transmitters operation. I was suprised to even see it installed when I got the unit. I’ll need to make a plug to fill the hole.