Even Artoo got in on the act at Maker Faire and made his very own flip book with the help from Eddie at lightmoves.net. Check out the video

Short video compilation of Artoo dancing with the children at Maker Faire.

I’m definitely getting into the fun part of the project. I spent part of the evening trying to add a servo to the front holo projector. It was a little more tricky than I thought it was going to be. I’d seen photos and vaguely remember a setup on one of the tables at C4, but until tonight I didn’t understood the nuances of the angles and forces need to move something with a servo, so it was frustrating and fun at the same time.

Most people seem to use the same basic method to move pie panels, doors, holo projectors etc. And that’s to convert servo rotation into a linear movement using a push rod attached to the servo horn.

I’d bought some random mini servos from Tower Hobbies a while ago (Hi-Tec HS-55), and a push rod/linkage assembly from ebay. Problem was the servo was too small to fit the rod attachments. I managed to improvise and this is what I finally came up with

Please ignore the kinks in the rod, it really should be straight, but I’d tried to copy what I’d seen at C4 and got it totally wrong 😀

If I was to do this again I’d probably skip the pre-made assemble and make something in acrylic and parts from the local hardware store.

I also created a short video to summaries and demo the new setup.

As I explain in the video it’s not perfect, and I need to affix the servo more permantely to the dome rather than using velcro and I’m not entirely confident the linkage to the back of the HP will last very long.

The good news the Hi-Tec servo is definitely powerful enough to move the HP and will probably work for the pie panels as well.

I also need to decide if I’m going to add some code to my micro-controller to automate random movement.

See Also:

• Slip Ring Servo Test

I finally got a chance to fully test out my slip ring last night with some servos.

I first had to finish soldering up my little boards that would handle signal routing and power.

Rather than try and explain in words and pictures how the setup works I made this short video to try and give a good overview and show the slip ring in action.

I still need to make little brackets to secure the D sockets to the boards, and decide the best place to locate them in Artoo.

See Also:

• Electrical System Update
• Slip Ring Spin Test
• Slip Ring – Cutting the Frame
• Slip Ring Update
• Slip Rings
• Variable 12-24V Converter

Here’s a videos I just found on YouTube of our appearance at WonderCon this year.

Just a short video testing out the newly mounted slip ring. No power is being routed yet, but I wanted to see how it worked in place and if there was any pulling on the cable.

I started work on my test slip ring tonight and hope to get it installed in the next few days and report back on a new group order.

The sample slip ring has eighteen 2A circuits and I plan on grouping together 6 or 8 for the +/- 12VDC uplink to the dome, leaving ten circuits for PWM/servo signals. To save on circuits I’m not planning on routing the +/- 5VDC from each of the PWM pairs through the slip ring. As a result each RC channel will require just one wire allocated on the slip ring. I’ll just tap of the 12VDC in the dome and re-create a separate 5VDC supply for the servos.

Out of the box the slip ring wires are loose and really needed protecting.

I bought some braided expandable nylon wire wrap from a local surplus electronics store for less than a dollar.

I wrapped the ends in electrical tape to hold things in place.

Now that I have the wire wrap in place I can start soldering the wires to the connectors.

Here’s an overview video on how I plan to implement the wiring

Here’s a short video from RoboGames last year. My droid pops up in a few spots.

I’m hoping to be there again this year.

Thanks Vern for sharing.